| Light |
Problem |
Resolution |
| Green |
Operating normally |
|
| Blinking Green |
|
The computer is in the suspended state
(Microsoft® Windows® 2000 and Windows XP). |
|
|
Press the power button, move the mouse, or press
a key on the keyboard to wake the computer. |
|
|
Blinks green several times and then turns off |
|
|
A configuration error exists. Check "Diagnostic
Lights" |
|
|
| Solid yellow |
|
The Dell Diagnostics is running a
test, or a device on the system board
may be faulty or incorrectly installed. |
|
|
Check "Diagnostic Lights" on page 23 to see if
the specific problem is identified |
|
| Blinking yellow |
|
A power supply or system board failure has
occurred. |
|
|
Check "Diagnostic Lights" on page 23 to see if
the specific problem is identified |
|
|
Solid green and a beep code during POST |
|
|
A problem was detected while the BIOS was
executing. |
|
See "Beep Codes" on page 26 for instructions on
diagnosing the beep code. Also, check "Diagnostic Lights" on page 23 to
see if the specific problem is identified
|
|
Solid green power light, no beep code and no
video during POST |
|
|
The monitor or the graphics card may be faulty
or incorrectly installed |
|
|
Check "Diagnostic Lights" on page 23 to see if
the specific problem is identified. |
|
|
Solid green power light and no beep code but the
computer locks up during POST |
|
|
An integrated system board device may be faulty. |
|
|
Check "Diagnostic Lights" on page 23 to see if
the specific problem is identified. |
|